Hello guys...
Now in this post, I have posted the design of Simulation of RC car in the Proteus.
Simulation is the virtual model of any real-time device where the internal circuitry and functionality is analyzed and verified in the software. Simulations are made to avoid hardware losses that occur due to directly experimenting on the hardware for the very first time.
I advise you not to make your RC car at first but to firstly design its simulation in the Proteus.
Now its time to feel and experience the beauty of engineering.
Lets Start...
- Download the library of RF module for Proteus
- Get the TX and RX code for the RC car from my previous post.
Note : In RX code change " f == ' 0 ' by f == ' S ' "
- Design the Transmitter part like this.
- Design the receiver part like this.
Now it will be finally like this.
- Now upload the transmitter and receiver codes in the transmitter and receiver arduino respectively.
Now Simulation is ready to run...
when the simulation is running you will see the following on the serial monitor as per your given command.
- when no button is pressed.
- When Command for forward motion is given.
same will be for Turning Left and Turning Right and Motors will start rotating in their respective direction.
It's all about Designing the Simulation of RC car in Proteus.
Thanks for reading.
In case of any query or recommendations please mention in the comment.
Mechanical Structure Of RC Car, Using ARDUINO & RF ASKModule.
- Items needed
4 BO Motor
4 Wheels
1 Servo
1 Plywood (12 x 15cm)
2 Screw- Bolt 2.5cm long (1mm)
2 Screw Bolt 4.5cm long (3mm)
Electronics Equipment
Designing of Remote Control ROBOT on Autodesk Fusion 360. Watch Video!
#Video
Diagram showing components.
Structure is balanced and & Centre of gravity lies at the centre of the structure.
360' View Mechanical Structure RC Car | Steering Robot
#Video
Robot Mechanical Structure.
#Video
For any queries please do comment.
Comments